4.2 LaserGRBL connecting with the laser engraver
*B.Click the Grbl, and select the Grbl Configuration
4.3 Grbl Configuration
*C. Find the$100(X-axis travel resolution), $101(Y-axis travel resolution)and set the Value according to your device
you can first engrave a small square with 30*30mm to confirm the pulse value. The processing is to check if error is
within 1mm after testing engraving is finished. If confirmed, that is the suitable pulse valueclick write and close to
4.2 LightBurn installation and procedure of the pulse adjustment
1 Download
You could visit and download the software from the link: https://lightburnsoftware.com/pages/trial-version-try-before-
you-buy
2 Install LightBurn
Click to install the software ( LightBurn need to charge, you may pay for the genuine to get the better experience,
here we will show by the trial for installation ), and click the next for next step.
To Next Page
Loading...
Need help?
General
