ATON AH66T - Page 57

ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 56
Primary Commands
Bass Level Control
Description: Adjusts Bass level in a zone. Status can be queried.
Examples:
&AH66,BAS,6,+<cr> INCREASES (+) the BASS (BAS)in ZONE SIX (6) by 1 dB.*
&AH66,BAS,9,-<cr> DECREASES (-) the BASS (BAS) in ZONE NINE (9) by 1 dB.*
&AH66,BAS,10,0<cr> Sets the BASS (BAS) in ZONE TEN (10) to FLAT (0).*
&AH66,BAS,2,+,6<cr> Sets the BASS (BAS) in ZONE TWO (2) to PLUS (+) SIX dB (6).
&AH66,BAS,3,-,2<cr> Sets the BASS (BAS) in ZONE THREE (3) to MINUS (-) TWO
dB (2).
&AH66,BAS,5,?<cr> QUERIES (?) the BASS (BAS) setting of ZONE FIVE (5).*
Example QUERY responses are:*AH66,BAS,5,0 (ZONE FIVE-BASS is FLAT),
*AH66,BAS,2,+,3 (ZONE FIVE-BASS is PLUS 3),
*AH66,BAS,5,-,4 (ZONE FIVE-BASS is MINUS 4).
*When increasing or decreasing the BASS setting by 1 dB, setting BASS to 0 (flat), or
querying settings, Parameter 3 is not used.
DND (Do Not Disturb) Control
Description: Enables, Disables or TOGGLES the DND setting in a zone. Status can be
queried.
Examples:
&AH66,DND,6,0<cr> Sets the DO-NOT-DISTURB (DND) setting in ZONE SIX (6) to OFF.
&AH66,DND,9,1<cr> Sets the DO-NOT-DISTURB (DND) setting in ZONE NINE (9) to
ON.
&AH66,DND,10,2<cr> TOGGLES (2) the DO-NOT-DISTURB (DND) setting in ZONE TEN.
&AH66,DND,2,?<cr> QUERIES the DO-NOT-DISTURB (DND) setting in ZONE TWO.
Possible QUERY responses are:*AH66,DND,2,0, or*AH66,DND,2,1 where 0=OFF and
1=ON.
Prefix Command Parameter 1
Zone #
Parameter 2 Parameter 3*
+/- dBs
&AH66 BAS 1-12 +/-/0/? 1-12
Prefix Command Parameter 1
Zone #
Parameter 2
DND State
&AH66 DND 1-12 0/1/2/?