ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 73
Tuner Query Command Response Structure
Tuner query commands ask the AH66T for information. They have the same formatting as
tuner commands.
If a query command is successfully decoded the AH66T will respond with information
relating to the query; RDS DATA, CURRENTLY SELECTED FREQUENCY, STEREO/MONO,
etc.
Sample Query Command and Response:
QUERY COMMAND: &AH66,R1,BAND,?<cr> This query is requesting the currently tuned
band of chassis one’s tuner.
QUERY RESPONSE: *AH66,R1,BAND,FM This response shows that chassis one’s
tuner is currently on the FM band.
If a query command is improperly formatted the response will be *AH66,NACK.
The following pages contain the RS-232 commands for the AH66T’s internal tuner. These
commands are included in the IR Library of the ATON configuration software.
To Next Page
Loading...