Sending and Receiving SMS
20
9 Sending and Receiving
SMS
This section tells you how to use the Short
Message System (SMS) features of the phone.
The SMS service allows the transmission or
reception of text messages to other devices. One
message can have up to 160 characters. SMS
service can only be used, if the device supports the
display of the subscriber number (CLIP).
Note
Your network operator must support the SMS
function.
Important
In order to receive a SMS, it is necessary that you
have already sent at least one SMS.
The sending number 062 210 000 and receiving
number 062 210 000 for SMS centre are already
preinstalled for Swisscom.
Tip
If the phone is connected to a PBX do not forget to
enter the access code (e.g. 0) before the sending
number of the SMS centre.
See “9.5 SMS Settings” for details on how to set the
sending number and receiving number for the SMS
centre.
9.1 Write an SMS (and send/
store it)
1. Press I )
Writing SMS
2. You will be prompted to write a message. When
done, press
e.
Note
The counter on the screen displays the number of
characters entered. If the maximum length of 160
characters is reached, you cannot enter any more
characters.
Press
* to switch between upper case and lower
case.
Press
X to delete the character to the left of the
cursor.
Aton_C29_EN.book Page 20 Monday, June 22, 2009 4:04 PM
To Next Page
Loading...