8
April 2008
e-motion™ Installation
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
Further safety precautions during Installation,
Service and Maintenance
• The machine weight is approx. 120kg. Always use
appropiate equipment for transportation.
• Disconnect the power cable from the socket, befo-
re working at the machine.
• The machine may only be operated in dry conditi-
ons and must be connected to a grounded mains
power socket.
• Check that all connectors are seated correctly. Fal-
se connections can cause irreparable damage, not
covered by warranty.
• For power cable routing remove the knock-out pla-
te on the appropriate side of the cabinet. Edge-
protection must be mounted once the knock-out
plate has been removed.
• Only qualified service personnel should perform
repairs.
• Electronic assemblies should only be changed with
the power switched off.
• Use only original Atronic parts for replacement.
• Atronic commboard and mainboard
Danger of explosion if battery is incorrectly repla-
ced! Check for correct polarity and replace with
the same or equivalent type only!
• The machine must not be cleaned using a high pres-
sure cleaner or a vapor jet and must not be instal-
led or operated in areas where high pressure clea-
ners or vapor jets are used. Use in dry conditions
only.
• Please refer to relevant Atronic service manuals
for further instructions on setup, operation and
maintenance.
To Next Page
Loading...
