2 Series 31XX, 32XX Furnaces | A. Safety
local electrical code requirements.
Handle the furnace carefully. Avoid dropping and jarring the furnace.
Avoid damage to cables. Do not let the power cables touch the heated
furnace shell.
Do not exceed maximum operating temperature. Operate the furnace
and accessories within the appropriate temperature range. Refer to the
appropriate manuals.
Dangerous high voltages present. Do not attempt to open the enclosure
or gain access to areas where you are not instructed to do so. Refer
servicing to qualied service personnel only.
Caution - Injury to the operator could occur if operational procedures are
not followed. Follow all steps or procedures as instructed and refer to
accompanying documents.
Ventilation – Slots and openings in the cabinet are provided for ventilation
and to ensure reliable operation of the product. To protect the unit from
overheating, those openings must not be blocked or covered. This product
should not be placed in a built-in installation, such as a wall cut-out unless
proper ventilation is provided. Hot temperatures will result.
Refer to manual. Before tuning the temperature controller, be sure to read
and understand the tuning instructions in the controller manual. Follow all
operating and other instructions carefully.
If it should become necessary to clean this equipment, disconnect the unit
from its power source rst. Do not use liquid cleaners, aerosols, abrasive
pads, scouring powders or solvents, such as benzene or alcohol. Use a
soft cloth lightly moistened with a mild detergent solution. Ensure the
surface cleaned is fully dry before reconnecting power.
Do not attempt to operate the temperature control system in ambient
temperatures higher then 120° F (49° C) without providing a cooling fan
or air conditioning.
To Next Page
Loading...
