24
press in the non-editing state to trigger the power slow-down function, release it to
stop the power slow-down.
3. Left button: Press to decrease parameter value or switch function state in parameter
editing state. Long press in the non-editing state to turn on the wire feeding function,
release it to stop the wire feeding.
4. Right key: Press to increase the parameter value or switch the function state in the
parameter editing state. Long press in the non-editing state to turn on the thread
rewinding function, and release it to stop thread rewinding.
Function introduction
1. Communication status: (status: normal\disconnected)
Shows whether the wireless connection is successful. "Normal" means that the
wireless communication is connected, and "disconnected" means that the wireless
communication is not connected.
2. Light emitting mode: (status: spot shooting\continuous)
Corresponding to the touch screen "light mode" parameter. The "continuous" light
mode and "spot shot" light mode can be adjusted.
3. Laser power: (range 0%-100%)
Corresponding to the "peak power" parameter of the touch screen, adjust the
maximum power during the stable light emission period.
4. Scanning width: (range 0mm-4mm)
Corresponding to the "scan width" parameter of the touch screen,Set the beam swing
width.
5. Spot enable: (status: on\off)
Corresponding to the touch screen "spot enable" parameter, turn on/off the swinging
spot.
6. Spotting time: (range: 0S-1.0S)
Set the light emission time in the spot mode corresponding to the "pulse time"
parameter in the "advanced parameters" interface of the touch screen.
7. Wire feeding speed: (range: 0%-100%)
To Next Page
Loading...