3
Wiring
Connect the thermostat wires to the power and to the load using solderless
connectors for copper wires.
4-wire Installation2-wire Installation
Thermostat mounting
1. Push the excess wires back inside the electrical box.
2. Secure the thermostat to the electrical box using the
provided screws.
3. Insert the screws through either the right or left pair of
mounting holes on the thermostat.
NOTE: If there is a protective film or sticker on the
thermostat’s screen, peel it off.
4. Apply power to the heating system. Verify the installation
by checking that the heater can be turned on by raising
the setpoint using the Up button and off by lowering the
setpoint using the Down button.
WARNING
Keep the thermostat’s air vents clean and free from obstructions.
To Next Page
Loading...
