PREPARING THE REMOTE CONTROL
First time use:
The remote control has a pre-installed lithium CR2025 battery. Remove the protective
tab to activate the remote control battery.
4
3
1
2
4
Replace the remote control battery:
The remote control requires a CR2025, 3V Lithium battery.
To replace this battery, follow the steps as below:
• Push the tab on the side of the battery tray towards the tray
• Slide the battery tray out of the remote control
• Remove the old battery. Place a new CR2025 battery into the battery tray with
the correct polarity as indicated
• Slide the battery tray back into the slot in the remote control
ATTENTION
If the remote control is operated near other products which generate infrared rays,
or if other remote control units also using infrared rays are near the unit, it may
operate incorrectly. Conversely, the other products may operate incorrectly.
Precautions Concerning Batteries:
• Then the remote control is not to be used for a long time (more than a month),
remove the battery from the Remote Control to prevent it from leaking.
•
If the batteries leak, wipe away the leakage inside the battery compartment and
replace the batteries with new ones.
• Do not use any batteries other than those specified.
• Do not heat or disassemble batteries.
• Never throw them in fire or water.
• Do not carry or store batteries with other metallic objects. Doing so could cause
batteries to short circuit, leak or explode.
• Never recharge a battery unless it is confirmed to be a rechargeable type.
To Next Page
Loading...
Need help?
General
