Chapter 5
Additional information
Disable / enable specific functions
In projects with public system access such as classrooms or conference rooms, it can
be desirable to lock it in a specific operation (input) mode or disable specific functions,
to avoid users changing the input signal.
Lock input:
To lock the sound bar in a specific input function (disable the operation mode selection),
turn the unit ON and switch to the desired audio source (e.g. AUX input). Press and hold
the ‘AUX’ button (or other selected function) on the remote control for about 5 seconds
to enable the lock. All status indicator LED’s will blink now simultaneous and the input
selection will be locked. (the input can’t be changed by the user).
Press and hold the selected function button again for about 5 seconds to disable the
lock. All status indicator LED’s will blink again simultaneous and the lock will be disabled.
Disable Bluetooth:
To disable the Bluetooth function, make sure the unit is in standby mode and press
and hold the BT button on the remote control for about 5 seconds. The blue Bluetooth
indicator LED will blink and the Bluetooth function will be disabled.
Press and hold the BT button again for about 5 seconds in standby mode to enable the
Bluetooth function again. The blue Bluetooth indicator LED will blink and the Bluetooth
function will be enabled again.
Hotel mode
In installations with multiple IMEO1’s installed throughout the building, it can be desirable
to assign custom Bluetooth ID’s to distinguish them from each other. Typical applications
are hotels, conference rooms, schools, ... The hotel mode function in the firmware offers
a solution for these applications.
Using the hotel mode, the Bluetooth ID can be adjusted to ‘AUDAC - IMEO1 + xxxx’
where ‘xxxx’ is a 4-digit number, representing the room number, class number, meeting
room number, ...
To Next Page
Loading...
