126 Homelin k
Programming the transmitter
(version B)
Applies to vehicles: with Homelink
Fig. 138 Distance between t he radiator grille and the
hand transm itter
Programming: phase 1 on th e control unit
1. Switch on the ignit ion (do not start the
engine) .
2 . Press and hold both of the outer Home-
Link buttons ¢ page 124, fig. 136 unti l
the LED @ turns off completely (about 20
seconds). This procedure clears the stand-
ard codes that were set at the factory and
does not need to be repeated again to
program the other buttons .
3. Briefly press the Homelink button that
you would like to prog ram .
4 . Wait unti l the LED@ beg ins to blin k
quickly. The Homelink module will now
remain in learning mode for
5 minutes .
5. Now stand in front of your vehicle with
the original hand transmitter for the ga-
rage door opener or for the device that
you would like to allocate to the Home-
Link button .
Programming: phase 2 on t he radiator
grille
6 . Hold the orig inal hand transmitter some-
what towa rds the center of your vehicle's
radiato r grille ¢
fig . 138 .
7 . Now activate (press) the hand transmit-
ter.
8 . Pay attention t o the tu rn signals fo r your
vehicle when activating the hand trans-
mitter . If the emergency flashers blink
three times, the programming was suc-
cessful. If the emergency flasher only
blinks one time, the S minute time limit
for the adaptation has expired or the pro -
gramming was unsuccessful. Repeat the
programming from step 3 on the controls
or se lect another distance from the radia-
tor grille.
9. If the garage door or other devices still
fail to be activated wit h the HomeL ink
control buttons after programming is
comple ted, it is possib le tha t these sys-
tems mig ht be work ing with a rolling code
instead of the normal fixed code .
A Roll-
ing code programming must be per-
formed ¢ page 127 .
Program the remaining two buttons accord ing
to the instructions mentioned above . Begin
similarly with the 3rd step if the program -
ming connection was successful for the first
button.
Remote contro l units for garage door openers
in Canada are set to stop transmitting radio
frequency signa ls after two seconds. This time
may not be suffic ient for the Homelink sys-
tem to learn the radio frequency signa l. Per-
form all other steps as described above.
Erasing the button s
.,. Switch on the ignition (do not start the en-
gine).
.,. Press and hold both of the outer buttons un-
til the LED @ turns off completely (about
20 seconds) to erase all of the buttons si-
multaneously .
.. Programmed buttons cannot be erased ind i-
vidua lly. Reprogram the buttons if necessa-
ry.
Reprogramming the buttons
.. Switch on the ign ition (do not start the en-
gine) .
.. To reprogram an individua l button, press
and hold the button unt il the LED@ st arts
to f lash quickly (after abo ut ten seconds).
Release the button immedia t ely. The Home-
Link module will now remain in learning
mode for 5 minutes.
.,. Continue with step 5.
To Next Page
Loading...
