you have stored. The system does not recog -
nize the load condition of your vehicle.
The effectiveness of the ti re pressu re monitor-
ing sys t em* will be impaired if you store nor -
mal load pressures but then operate the vehi -
cle at its maximum load ¢ ,& .
See the illustration ¢
fig. 189 for the location
of the label on dr iver's side B-pillar (color of
the actual labe l and exact location on the ve-
hicle will vary slig htly) .
Note that the fo llowing tab le is accurate at
the t ime of go ing to press and is subject to
Model Tire designation
Engine
A4 Sedan: 225/55 Rl6 95 H
2 .0 liter All Season
4 -cylinder
245 / 45 Rl 7 95H
All Season
24 5/ 40 Rl8 93Y
High Performance
2 25/5 0 Rl 7 94H
All Season
24 5/ 40 Rl 8 93H
All Season
2 55 /35 Rl9 96Y XL
High Performance
allroad: 22 5/55 Rl 7 9 7 H
2.0 liter All Season
4 -cylinder
245 / 45 Rl 8 l00H
All Season
245 / 45 Rl8 96 Y
High Performance
245 / 40 Rl9 98Y XL
High Performance
Tire s an d wheel s 235
change. In the event of discrepancies, the ti re
pressure label is located on the driver's side B-
pillar always takes precedence .
The table below lists the recommended cold
ti re inflation pressures for the Audi mode l
covered by your Owner's Literature at the vehi-
cle's capacity weight and the t ire sizes instal-
led on the respective models as orig inal
equipment, or as a factory option.
Tire pressure
normal load condition full load condition
(up to 3 occupants)
front rear front rear
PSI kPA PSI kPA PSI kPA PSI kPA
32 220 29 200 33 230 35 240
32 220 29 200 33 230 35 240
32 220 29 200 33 230 35 240
33 230 30 210 35 240 36 250
33
230 32 220
36
250
38
260
32 220 30 210 35 240 35
240
30 210 30 210 33 230 36 250
32 220 32 220 33 230 36 250
30 210 30 210 33 230 36 250
32 220 29 200
35
240
38
260
•
•
To Next Page
