4 8 Clear v ision
@ Tips
- The light sensor* for headlight control is
located in the rear view m irror mount.
You should therefore not apply any st ick-
ers to the windsh ield in this area in order
to prevent malfunctions or failures.
- Some exterior lighting functions can be
adjusted
c> page 48.
- When you remove your key from the igni-
tion while the vehicle's lights are turned
on, a buzzer sounds as long as the driv-
er's door is open .
- In cool or damp weather, the ins ide of
the headlights, turn signals and tail
lights can fog over due to the tempera-
ture difference between the inside and
outside. They will clea r s hor t ly after
switching t hem on. This does not affect
the service life of t he lighting.
- In the even t of a light sensor malfunc-
tion, the driver is not ified in t he instru-
ment cluster disp lay¢
page 22.
Turn signals and high beam lever
The lever operates the turn signals, the high
beams and the headlight flasher .
Fig. 4 1 Turn signal and high beam lever
Turn signals ¢i ¢
The turn signals activate when you move the
lever into a turn s ignal pos ition when the ign i-
tion is switched on.
(D - right turn signal
@ - left tur n signa l
The turn s ignal blinks three times if you just
tap the lever .
High beams and headlight flasher [D
Move the lever to the correspon ding posit io n:
@ - high beams on
@ - high beams off or headlight flasher
The indicator light ii in the instrument clus-
ter turns on .
Not es on these features
- The turn signals on ly wor k w ith t he ignition
t urned on. The indicator ligh t s
Ct or a in
the instrument cluster also blink.
- After you have turned a co rner, the turn sig -
na l switches off aut oma t ically.
- The
high beam works on ly when the head-
lights a re on. The indicator ligh t
II in the
instrument cluster illuminates w hen the
high beams are on .
- The
headlight flasher works only as long as
you ho ld the lever - even if there a re no
lights switched on . The indicator light
II in
the instrument cluster illuminates when you
use the headlight flasher.
A WARNING
- -
Do not use the high beam or headlight
flasher if you know that these could blind
oncom ing traffic.
Adjusting exterior lighting
The functions ore selected in the radio or
MMI" .
.,. Select: !CARI function button> Exterior
light ing.
Or
.,. Select: !CARI function button > Car systems*
control button > Vehicle setting s> Exterior
lighting .
Coming home (light when leaving car}*,
Leaving home (light when unlocking car)*
The coming home function illuminates the
area around the vehicle when the ignition is
switched off and th e dr iver's door is opened.
Depend ing on vehi cle equ ipment, the function
can be switched on and off or the length of
time the lights remain on* can be adj usted . ..,.
To Next Page
Loading...
