(D Note
Let the partition net roll up slowly to pre-
vent damage.
Partition net (seatback tilted forward)
Applies to vehicles: with part ition net
Fig. 79 Folded backrest: install ing the part it ion net
Fig. 80 Folded backrest: hanging t he par tit ion net
Installing
• Tilt the seatback forward r::;, page 69.
0
0
0
~
gi
• Affix the partit ion net to the recesses on the
retaining ra ils
(Dr::;, fig. 79 and slide it to-
wards the left side of the vehicle until it
latches @ .
Hanging
• Pull the net upward and hang the crossbar
in the front eyelets
over the front seats
r=> fig. 80 -arrow-.
Removing
• Slide the partit ion net to the right and lift it
out of the retaining rails
r::;, fig. 79.
@ Note
- You must remove the partition net be-
fore fo lding the backrest back into the
upright position.
Seats and storage 71
- Let the partition net roll up slowly to
prevent damage.
Cargo net
Applies to vehicles: with cargo net
The cargo net prevents small objects from
sliding.
Fig. 81 Luggage compartment: cargo net stretched
out
Fig. 82 Luggage compartment: cargo net at the top of
the luggage compartment
Net stretched out
• First hang the first hooks in the mounting
eyelets and then hang the rear hooks
r::!>fig. 81.
Net at the top of the luggage
compartment
• Hang the hooks on the cargo net in the tie-
downs on the floor at the rear of the lug-
gage compartment
r::;, fig. 82.
• Fold down the bag hooks at the upper area
of the luggage compartment down, pull the
net up and hang the eyelets on the net on
the hooks .
You can also use the hooks
r=> fig. 82 to hang
light pu rses, bags, etc.
1JJ,,
To Next Page
Loading...
