~
Automatic transmission: Step on the brake
pedal and move the selector lever to the P
or N position .
~
Press the key c::> fig. 94 - the engine will
start.
Switching the ignition on/ off
If you wou ld like to switch the ignition on
without starting the engine, follow t hese
steps :
~
Insert the key into the ignition lock.
~
Press the key briefly without pressing the
clutch pedal (for manual transmissions) or
the brake pedal (for automatic transmis-
sions).
~
To switch the ignition off, press the key
again.
When starting the engine, major electr ical
loads are switched off temporarily .
You can only remove the key with the ignition
switched off.
If the engine should not start immedia t ely,
the starting process is automatically stopped
after a short time. Repeat starting procedure.
A WARNING
- Never allow the engine to run in confined
spaces - danger of asphyxiation.
- Never remove the ign ition key from the
ignition look while the vehicle is moving.
Otherw ise, the steering lock could sud-
denly engage and you would not be able
to steer the vehicle.
- Always take the key with you whenever
you leave your vehicle . Otherwise, the
engine could be started or electr ical
equipment such as the power w indows
could be operated. This can lead to seri-
ous inj ury.
- Never leave child ren or persons requiring
assistance unattended in the vehicle. The
doors can be locked using t he remote
transmitter, preventing people from es-
caping from the vehicle on their own in
the event of an emergency. Depending
on the time of year, people inside the ve-
On th e ro a d 81
hicle can be exposed to very high or very
low temperatures.
(D Note
Avoid high engine rpm, fu ll throttle and
heavy engine loads unti l the engine has
reached operating tempe rat ure - other-
wise you risk engine damage.
@ For the sake of the environment
Do not let the engine run while parked to
warm up. Begin dr iving immediately. This
reduces unnecessary emissions.
@ Tips
- If the key cannot be removed from the
ignition lock, you have to pull the me-
chanical key out of the master key in or-
der to be able to lock the vehi-
cle<=:>
page 35 .
- After starting a cold engine, there may
be a brief period of increased noise be-
cause the oil pressure must first build up
in the hydraulic valve adjusters. This is
normal and not a cause for concern.
- If you leave the vehicle with the ignition
switched on, the ignit ion w ill switch off
afte r a certa in period of t ime. Please
note that electrical equipment such as
exterior ligh t s will switch off as well
when that happens.
To Next Page
Loading...
