Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
10 – Engine Assembly
1 Engine, Removing and Installing
⇒ “1.1 Engine, Removing”, page 4
⇒ “1.2 Engine, Securing to Engine and Transmission Holder”,
page 31
⇒ “1.3 Engine, Installing”, page 31
1.1 Engine, Removing
⇒ “1.1.1 Engine, Removing, Vehicle with Generator”, page 4
⇒ “1.1.2 Engine, Removing, Vehicle with Starter Generator”, page
16
1.1.1 Engine, Removing, Vehicle with Gener‐
ator
Special tools and workshop equipment required
♦ Engine Support Bridge - 10-222A-
♦ Engine Support Bridge - Spindle - 10-222A/11-
♦ Engine Sling - 2024A-
♦ Shop Crane - VAS6100-
♦ Engine Support Bridge Adapter - 3147-
♦ Ring Wrench 7-Piece Set - 3337-
♦ Torque Wrench 1332 Insert - Ring Wrench - 16mm -
VAG1332/14-
♦ Shop Crane - VAS6100-
♦ Engine Bung Set - VAS6122-
♦ Coolant Collection System - VAS5014- or Shop Crane - Drip
Tray - VAS6208-
♦ Hose Clip Pliers - VAS6362-
♦ Torque Wrench Adapter - VAS6948-
♦ Locking Pin - T10060A-
♦ Engine Support - Supplement Kit - Adapter - T40093/6- from
the Engine Support - Supplement Kit - T40093B-
♦ Wrench - 21mm - T40263-
♦ Adapter - T40314-
♦ Protective Eyewear
♦ Safety Gloves
Procedure
• Remove the engine upward without the transmission.
• During installation, all cable ties must be installed at the same
location.
– Observe the guidelines for clean working conditions. Refer to
⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr.
00 ; Repair Information; Guidelines for Clean Working Condi‐
tions .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4 Rep. Gr.10 - Engine Assembly
To Next Page
Loading...
