Audi A5 2016 - Sub-Assembly Bracket, Removing and Installing; Engine Support, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.5 Sub-Assembly Bracket, Removing and
Installing
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 13 ; Cylinder Block, Belt Pulley Side; Sub-Assembly
Bracket, Removing and Installing .
1.6 Engine Support, Removing and Instal‐
ling
⇒ “1.6.1 Left Engine Support, Removing and Installing”,
page 49
⇒ “1.6.2 Right Engine Support, Removing and Installing”,
page 50
1.6.1 Left Engine Support, Removing and In‐
stalling
Removing
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
– Lift the clamp -3-, remove and free up the coolant hose.
– Disconnect the connector -1- for the Engine Coolant Level
Sensor - G32- .
– Remove the bolt -4-, and push the coolant expansion tank
-2- to the side.
– Remove the upper bolts -2- for the engine support -1-. (Shown
with the engine removed.)
– Remove the left support bearing. Refer to
⇒ “2.3.2 Support Bearing, Removing and Installing”,
page 40 .
– Remove the left engine mount. Refer to
⇒ “2.3.1 Engine Mount, Removing and Installing”, page 38 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Cylinder Block, Belt Pulley Side 49