Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 Air Filter
⇒ “2.1 Overview - Air Filter Housing”, page 149
⇒ “2.2 Air Filter Housing, Removing and Installing”, page 150
2.1 Overview - Air Filter Housing
1 - Snow Screen
❑ Market-Specific Version
2 - Air Duct
❑ On the lock carrier
❑ Clean off any salt and
dirt
3 - Sealing Piece
4 - Water Drain
❑ Clean
5 - Mount
❑ For the air filter housing
6 - Air Duct
❑ For market-specific ver‐
sions with Intake Air
Switch-Over Valve -
N335-
❑ Not included when re‐
placing the air filter low‐
er section. Refer to
⇒ page 151 .
7 - Air Filter Lower Section
❑ Clean off any salt and
dirt
❑ Market-specific ver‐
sions: when replacing
the air filter lower sec‐
tion, the Intake Air
Switch-Over Valve -
N335- is omitted. Refer
to ⇒ page 151 .
❑ Removing and instal‐
ling. Refer to
⇒ “2.2 Air Filter Housing,
Removing and Installing”, page 150 .
8 - Air Filter Element
❑ Use an original air filter element. Refer to the Parts Catalog.
❑ Replacement intervals. Refer to the ⇒ Maintenance Intervals; Rep. Gr. 03
❑ Removing and Installing. Refer to ⇒ Maintenance ; Booklet 830 ; Maintenance Work; Air Filter; Filter
Element, Replacing; Housing, Cleaning
9 - Bolt
❑ 3.5 Nm
❑ Thread cutting
❑ Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specifi‐
cation.
10 - Air Filter Upper Section
❑ Clean off any salt and dirt
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Air Filter 149