Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connector -1-.
– Place a cloth underneath to catch any escaping coolant.
– Loosen the hose clamps -2- to clamp off the coolant hoses
with the -3094- and remove them.
– Remove the bolts -arrow- and the After-Run Coolant Pump -
V51- .
Installing
Install in reverse order of removal and note the following:
• Secure all hose connections with hose clamps that match the
ones used in series production. Refer to the Parts Catalog.
– Fill with coolant. Refer to ⇒ Fig. ““Coolant, Filling”“ , page 97 .
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Tightening Specifications
♦ Refer to ⇒ “2.2 Overview - Electric Coolant Pump”, page 100
2.6 Coolant Pump, Removing and Installing
Removing
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
– Drain the coolant. Refer to
⇒ “1.3 Coolant, Draining and Filling”, page 96 .
– Disconnect the connectors -2 to 5-.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Coolant Pump/Coolant Thermostat 105
To Next Page
Loading...
