Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connector -arrow- for the A/C compressor.
– Remove the lower bolts -3- and the left engine support -1-.
Installing
Install in reverse order of removal and note the following:
• Replace the bolts that were tightened with an additional turn
after removing them.
– Connect the coolant hose to the connector coupling. Refer to
⇒ Fig. ““Connect the Coolant Hose to the Connector Cou‐
pling”“ , page 119 .
– Install the support bearing. Refer to
⇒ “2.3.2 Support Bearing, Removing and Installing”,
page 40 .
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Subframe Mount”, page 35
1.6.2 Right Engine Support, Removing and
Installing
Removing
– Disconnect the battery. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 ; Battery; Battery, Disconnecting and Connecting .
– Remove the right engine mount. Refer to
⇒ “2.3 Engine Mount, Removing and Installing”, page 38 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
50 Rep. Gr.13 - Crankshaft, Cylinder Block
To Next Page
Loading...
