Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the left and right bolt -2- and push the radiator bracket
-1- with the bolt toward the front in direction of -arrow-.
– Release the left and right catches in direction of -arrows- and
remove the retaining pin -1- for the radiator upward.
– Remove the radiator.
– Press the fan shroud left and right locking tabs at the same
time in direction of -arrow- and remove the fan shroud upward
from the radiator.
Installing
Install in reverse order of removal and note the following:
• If there are small impressions on the slats. Refer to ⇒ Serv‐
icing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 00 ;
Repair Information; Radiator and Condenser Assembly .
• Change all of the coolant after replacing the radiator.
– Install the charge air cooler. Refer to
⇒ “2.3 Charge Air Cooler, Removing and Installing”,
page 134 .
– Install the headlamps. Refer to ⇒ Electrical Equipment; Rep.
Gr. 94 ; Headlamps; Headlamp, Removing and Installing .
– Connect the coolant hose to the connector coupling. Refer to
⇒ Fig. ““Connect the Coolant Hose to the Connector Cou‐
pling”“ , page 119 .
– Fill with coolant. Refer to ⇒ Fig. ““Coolant, Filling”“ , page 97 .
Tightening Specifications
♦ Refer to ⇒ “4.1 Overview - Radiator/Radiator Fan”, page 118
♦ Refer to ⇒ “2.1 Overview - Air Filter Housing”, page 149
♦ Refer to ⇒ Body Exterior; Rep. Gr. 50 ; Lock Carrier; Overview
- Lock Carrier .
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4. Radiator/Radiator Fan 123
To Next Page
Loading...
