Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Loosen the threaded connections -arrows- and slide the
clamping sleeves toward the rear.
CAUTION
Risk of Damaging the Coupling Due to Improper Handling
– Coupling must not be bent more than 10°.
– Do not load the coupling on the cable.
– Slightly lower the front muffler -2- and secure as shown with a
cable tie -1-.
– Remove the nut -arrow- and move the bracket -1- and wiring
harness to the side.
– Remove the air filter housing. Refer to
⇒ “2.2 Air Filter Housing, Removing and Installing”,
page 150 .
All additional procedures are described. Refer to ⇒ Servicing –
4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 21 ; Turbocharg‐
er; Turbocharger, Removing and Installing .
Installing
Additional procedures:
– Install the air filter housing. Refer to
⇒ “2.2 Air Filter Housing, Removing and Installing”,
page 150 .
– Fill with coolant. Refer to ⇒ Fig. ““Coolant, Filling”“ , page 97 .
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Tightening Specifications
♦ Refer to ⇒ “1.1 Overview - Muffler”, page 169
♦ Refer to ⇒ Servicing - 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 21 ; Charge Air System; Overview - Charge Air Hose
Connections .
1.2.2 Turbocharger, Removing and Installing,
Vehicles with Particulate Filter
Removing
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Turbocharger 131
To Next Page
Loading...
