Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
CAUTION
Risk of damaging the coupling due to improper handling.
– Coupling must not be bent more than 10°.
– Do not load the coupling on the cable.
– Slightly lower the front muffler -2- and secure as shown with a
cable tie -1-.
– Seal the front muffler with the -VAG1687/3- and -
VAG1687/15- .
– Connect the -VAG1687- with the connection -5- on the -
VAG1687/6- .
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 21 ; Charge Air System; Charge Air System, Checking
For Leaks .
Assembling
Assemble in the reverse order of removal. Note the following:
• Secure all hose connections with hose clamps that match the
ones used in series production. Refer to the Parts Catalog.
– Install the lock carrier cover. Refer to ⇒ Body Exterior; Rep.
Gr. 63 ; Front Bumper .
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Air Filter Housing”, page 149
♦ Refer to ⇒ “1.1 Overview - Muffler”, page 169
♦ Refer to ⇒ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep.
Gr. 21 ; Charge Air System; Overview - Charge Air System .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Charge Air System 137
To Next Page
Loading...
