Audi A5 2016 - Page 176

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Exhaust System, Installing without Tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
8 - Front Muffler
❑ With coupling:
♦ Do not bend more than 10°
♦ Do not load on cable
♦ Do not damage wire mesh at decoupling element
❑ Removing and installing. Refer to ⇒ “1.3 Front Muffler, Removing and Installing”, page 174 .
❑ Exhaust System, Installing without Tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
9 - Gasket
❑ Always replace after removing.
10 - Nut
❑ 23 Nm
11 - Mount
❑ Always replace if damaged
❑ Check the pretension. Refer to ⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
❑ Equipped on some models
12 - Bolt
❑ 23 Nm
13 - Front Clamping Sleeve
❑ Before tightening, align the exhaust system without tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
❑ Tighten the threaded connections equally to 23 Nm.
❑ Installation position. Refer to ⇒ Fig. ““Front Clamping Sleeve - Installation Position”“ , page 171 .
14 - Retaining Loop
❑ Always replace if damaged
❑ Exhaust System, Installing without Tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
15 - Bracket
16 - Bolt
❑ 23 Nm
17 - Rear Muffler
❑ Original equipment one unit with the center muffler. If a repair is required replace each separately
❑ Separating point. Refer to ⇒ “1.2 Exhaust Pipes/Mufflers, Disconnecting”, page 173 .
❑ Exhaust System, Installing without Tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
18 - Rear Clamping Sleeve
❑ Before tightening, align the exhaust system without tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”, page 177 .
❑ Tighten the threaded connections equally to 23 Nm.
❑ Installation position. Refer to ⇒ Fig. ““Rear Clamping Sleeve - Installation Position”“ , page 171 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
170 Rep. Gr.26 - Exhaust System, Emission Controls