Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connector -2- for the Mass Airflow Sensor -
G70- .
– Remove the vacuum hose -3-.
– Loosen the hose clamp -4- and remove the air duct hose.
– Pull the air filter housing -1- upward.
– Release the latch in direction of -arrow B- and open the E-box
-1- in direction of -arrow A-.
– Remove the nut -2- and free up the B+ wire.
– Free up the upper wiring duct.
CAUTION
Risk of Destroying a Used Ribbed Belt by Reversing the Run‐
ning Direction
– Mark the running direction before removal.
– Pay attention to the running direction when reinstalling.
– Turn the tensioner in direction of -arrow- to release the tension
on the ribbed belt.
– Secure the tensioner using the -T10060A- .
– Remove the ribbed belt.
– Disconnect the connector -1- for the Charge Air Pressure Sen‐
sor - G31- .
– Loosen the screw-type clamp -2- and remove the air duct pipe
from the Throttle Valve Control Module - GX3- .
– Loosen the left front wheel housing liner in the front area and
push slightly toward the rear. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Wheel Housing Liner; Overview - Front Wheel Hous‐
ing Liner .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
18 Rep. Gr.10 - Engine Assembly
To Next Page
Loading...
