Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Free up the wires on the heat shield -1-.
– Remove the nuts -arrows- and bolts -2- and remove the heat
shield. (Shown with the particulate filter removed).
– Remove the connector -2- for the Exhaust Gas Temperature
Sensor 3 - G495- from the bracket and disconnect.
– Open the clip -3- and free up the vacuum hose.
– Remove the bolt -1-, and push aside the bracket. There are
different versions.
– Remove the particulate filter.
– Disconnect the connector -2- for the Oxygen Sensor 1 After
Catalytic Converter - GX7- -1- and free up the wires.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
26 Rep. Gr.10 - Engine Assembly
To Next Page
Loading...
