Audi A5 2016 - Page 43

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7 - Transmission
8 - Nut
❑ Tightening specifications. Refer to ⇒ Rep. Gr. 34 ; Subframe Mount; Overview - Subframe Mount .
❑ Only remove when the transmission mount must be separated from the transmission support
9 - Transmission Support
❑ Removing and installing. Refer to ⇒ “2.4 Transmission Mount, Removing and Installing”, page 41 .
10 - Bolt
❑ Tightening specifications. Refer to ⇒ Rep. Gr. 34 ; Subframe Mount; Overview - Subframe Mount .
11 - Bolt
❑ 9 Nm
12 - Bracket
❑ For the connector
Overview - Dual Clutch Transmission Mount
1 - Bolt
❑ Tightening specifica‐
tions. Refer to ⇒ 7-
Speed Dual Clutch
Transmission; Rep. Gr.
34 ; Subframe Mount;
Overview - Subframe
Mount .
2 - Tunnel Crossmember
❑ Removing and instal‐
ling. Refer to ⇒ 7-Speed
Dual Clutch Transmis‐
sion; Rep. Gr. 34 ; Sub‐
frame Mount; Overview
- Subframe Mount .
3 - Stop
❑ For the transmission
mount
4 - Transmission Mount
❑ Removing and instal‐
ling. Refer to
⇒ “2.4 Transmission
Mount, Removing and
Installing”, page 41 .
5 - Transmission
6 - Nut
❑ Tightening specifica‐
tions. Refer to ⇒ 7-
Speed Dual Clutch
Transmission; Rep. Gr.
34 ; Subframe Mount;
Overview - Subframe
Mount .
❑ Only remove when the
transmission mount
must be separated from the transmission support
7 - Transmission Support
❑ Removing and installing. Refer to ⇒ “2.4 Transmission Mount, Removing and Installing”, page 41 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Subframe Mount 37