Audi A5 2016 - Page 45

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connector -2- for the electro-hydraulic engine
mount solenoid valves.
Left Engine Mount:
– Remove the bolt -1- for the support bearing.
Right Engine Mount:
– Remove the right support bearing. Refer to
⇒ “2.3.2 Support Bearing, Removing and Installing”,
page 40 .
– Loosen the hose clamp -arrow- and remove the air duct hose.
– Remove the nut -arrow- and free up the ground wire.
– Remove the bolt -arrow- and free up the bracket -1- with the
wiring harness.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Subframe Mount 39