Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Free up the wires on the heat shield -1-.
– Remove the nuts -arrows- and bolts -2- and remove the heat
shield. (Shown with the particulate filter removed).
– Remove the connector -2- for the Exhaust Gas Temperature
Sensor 3 - G495- from the bracket and disconnect.
– Open the clip -3- and free up the vacuum hose.
– Remove the bolt -1-, and push aside the bracket. There are
different versions.
All additional procedures are described. Refer to ⇒ Servicing –
4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 15 ; Valvetrain;
Camshaft, Removing and Installing .
Installing
Additional procedures:
• Secure all hose connections with hose clamps that match the
ones used in series production. Refer to the Parts Catalog.
– Install the ignition coils. Refer to ⇒ Servicing – 4-Cylinder 1.8L;
2.0L 4V TFSI Engine; Rep. Gr. 28 ; Ignition System; Ignition
Coils, Removing and Installing .
– Install the upper timing chain cover. Refer to ⇒ Servicing – 4-
Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 15 ; Timing
Chain Cover; Timing Chain Cover, Removing and Installing .
– Install the air filter housing. Refer to
⇒ “2.2 Air Filter Housing, Removing and Installing”,
page 150 .
Tightening Specifications
♦ Refer to
⇒ Fig. ““Heat Shield - Tightening Specification”“ , page 62
♦ Refer to
⇒ Fig. ““Heat Shield Bracket - Tightening Specification”“ , page
62
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
74 Rep. Gr.15 - Cylinder Head, Valvetrain
To Next Page
Loading...
