....
N
0
CJ
'<I:
....
I.Cl
U'"I
M
I.Cl
......
Programming buttons
Applies to vehicles: with garage door opener (Homelink}
Fig. 37 Headl iner: Cont rol pan el
You can program bot h f ixed code and rolling code
systems using this procedure .
Programming / reprogramming button s
• Switch the ignition on .
.. Press and hold the button in the head liner that
you wou ld like to program for at least 10 sec-
onds. Or
• Se lect:
~I C~A~R~I funct ion but t on > (Car)* systems
contro l button > Vehicle setting s > garage
door opener > Program garage door opener .
.. Follow t he inst ruct ions in the Infota inme nt sys-
tem .
Deleting button programming
The programmed but tons cannot be de leted ind i-
vid ually, they must be de leted a ll at once . Repro-
gram t he bu ttons if necessary .
.. Select: the
ICARI fu nction button > (Car) * sys-
tems
control button > Vehicle settings > Ga-
rage door opener > Clear program settings >
Yes.
Displaying the version/ status/country code
.. Se lect: I CAR I funct ion button > (Car)* systems
contro l butto n > Vehicle settings > Garage
door opener > Version information .
(D Tips
The garage door opene r may need to be
synchronized with the-system motor after the
programm ing . Follow the manufacture rs in-
st ructions for do ing th is .
Open ing and closing
Operation
Applies to vehicles: with garage door opener (Homelink)
Requireme nts The butt on in the roof head liner
mus t be programme d
~ page 4 3 and the veh icle
mus t be with in ran ge of t he system, such as the
garage doo r.
• Press the bu tton to ope n t he garage door. The
LED@ ~
page 43, fig . 3 7 blink s or tur ns on .
• Press t he bu tton again to open the garage
door.
@ Tips
To ope n or close the garage door, do not
press t he button lon ger ten seconds or t he
garage door opener will switch to program-
ming mo de .
43
To Next Page
Loading...
