....
N
0
CJ
'<I:
....
I.Cl
U"I
M
I.Cl
......
Rear head restraints
Fig. 56 Rear seat s: Head restra int
•
Fig. 57 Rear head restra ints: release
If there is a passenger on the rear center seating
position, slide the center head restraint upward
at least to the next notch
~
& in Proper adjust-
ment of head restraints on page 129.
Adjusting the head restraints
• To move the head restraint up, hold it at the
sides with both hands and slide it upward until
you feel it lock into place.
• To move the head restraint down, press the
button -arrow- ¢
fig. 56 and slide t he head re-
straint downward.
Removing the head restraints
• Move the head restraint upward as far as it can
go .
• Press the release ¢
fig . 57 with the mechanical
key -=>
page 30 and the button -arrow- ¢ fig. 56.
Pull t he head restrain t out of the backrest at
t he same time ¢ &_ .
Installing th e head rest raints
• Slide the posts on the head restraint down into
the gu ides unti l you feel the posts lock into
pla ce.
Seats and storag e
• Press the button -arrow- -=> fig. 56 and slide the
head restraint all the way down . You shou ld not
be able to pull the head restraint out of the
backrest.
So that the driver can have a better view to the
rear, the head restraints should be pushed down
completely when the rear seats are not occupied .
A WARNING
-
- Only remove the rear seat head restraints
when necessary in order to install a child
seat . Install the head restraint again imme -
diately once the child seat is removed. Driv-
ing without head restraints or with head re-
st ra ints that are not prope rly adjusted in-
creases the risk of serious or fat al neck in-
jury dramat ica lly.
- Read a nd heed all WARNINGS
¢page 128 .
Memory function
Description
Appl ies to vehicles : with memory funct ion
Using the memory function, you can quickly and
easily store a personal seat profile for the driver
and front passenger and recall the sett ings . The
memory funct ion is control led using the remote
contro l key and the memory buttons in the dr iv-
er's/front passe nger's door* .
The driver's seat prof ile is stored again and as -
signed to the remote control key each t ime the
vehicle is locked. When you open the door, the
seat profile is automatically recalled. If two peo-
ple use t he vehicle , it is recommended t hat each
person always uses "their own" remote control
key.
Two seat profiles can be stored using the memo-
ry bu ttons in the driver 's/front passenger's
doo r*. Once they are stored, these seat prof iles
can be selected at any time .
The following sett ings are stored :
57
To Next Page
Loading...
