Assistance systems
- Under certain conditions such as ruts in the
road, a banked roadway or crosswinds, the
corrective steering alone may not be enough
to keep the vehicle in the middle of the lane.
- For safety reasons, active lane assist must
not be used when there are poor road and/
or weather conditions such as slippery
roads, fog, gravel, heavy rain, snow and the
potential for hydroplaning. Using active lane
assist under these conditions may increase
the risk of a crash.
Switching on/off
Applies to: vehicles with Audi active lane assis t
-
;g
9
::i
00
CD
Fig. 99 Turn signa l lever: button for active lane assist
Fig. 100 Windshield: camera window for active lane assist
• Press the button to switch the system on and
off ¢
fig. 99. The. or. indicator light in
the instrument cluster turns on or off.
Indicator lights
• Ready:
the indicator light turns on when the
system is ready for use . The system can now be
operated .
• Not ready: the indicator light turns on if the
system is switched on but is inoperable. This may
be due to the following reasons:
96
- There is no lane marker line.
- The relevant lan e marker lines are not detected
(for example, markings in a construction zone
or because they are obstructed by snow, dirt,
water or lighting).
- The vehicle speed is below the activation speed
of approximate ly 40 mph (65 km/h).
- The lane is too narrow or too wide.
- The curve is too narrow.
- The driver's hands are not on the steering
wheel.
@ Tips
Make sure the camera's field of view
¢ fig. 100 is not obstructed by stickers or any-
thing else. For information on cleaning, see
¢page 221.
View in instrument cluster display
Applies t o: vehicles with Aud i active la ne ass ist
Fig. 101 Instrument cluste r: active lane assist is switched
on and providing warn ings
Fig. 102 Instrument cluster: act ive lane ass ist is switched
on but not ready to provide warn ings
You can call up the active lane assist display us-
ing the buttons in the multifunction steering
wheel
¢page 19. Ill>
To Next Page
Loading...
