Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
17 - Spreader clip
18 - Grommet
2.3 Upper Intake Manifold Assembly Overview
1 - Intake Manifold Tuning
(IMT) valve position sensor -
G513-
2 - 2.5 Nm
3 - 2.5 Nm
4 - Actuator for intake manifold
change over
❑ Installed location of
tooth segments for vari‐
able intake manifold
⇒ page 17
❑ As replacement part to‐
gether with -24-
5 - Seal
❑ Replace if damaged
❑ Lift out with screwdriver
to replace
❑ Press in by hand
6 - Ball pin, 2.5 Nm
7 - Intake manifold, upper
❑ Removing and installing
⇒ page 29 .
8 - Throttle valve control mod‐
ule -J338-
9 - 5 Nm
10 - Wire harness retainer
11 - Seal
❑ Replace
12 - Intake Manifold Runner
Control (IMRC) valve -N316-
13 - 2.5 Nm
14 - Intake Air Temperature (IAT) sensor -G42- / Manifold Absolute Pressure (MAP) sensor -G71-
15 - O-ring
❑ Replace
16 - 2.5 Nm
17 - Crankcase housing ventilation pressure regulator valve
18 - O-ring
❑ Replace
Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
16 Rep. Gr.24 - Fuel injection system
To Next Page
Loading...
