Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– To fasten high-pressure line (14 mm) at high pressure pump
use torque wrench -V.A.G 1331- with ratchet -V.A.G 1331/1-
and socket 14 mm -3150- .
– To fasten high-pressure line (17 mm) to high pressure pump,
use torque wrench -V.A.G 1331- with reversible ratchet -V.A.G
1331/1- and socket -T40055- .
Tightening Specifications
Component Nm
Intake manifold lower-part to cylinder head 10
High pressure lines to High pressure pump 25
Fuel rail 25
5.4 Fuel Injectors
Special tools and workshop equipment required
♦ Tool set -T10133-
High-Pressure Fuel Injector - Component Overview
1 - Radial adjustment - Replace if damaged
2 - Combustion chamber seal (Teflon seal) - replace, the seal
must not be greased or be handled with any other lubricant
during installation
3 - Groove on fuel injector
4 - Spacer ring - Replace if damaged
5 - O-ring - replace, lightly coat with clean engine oil during in‐
stallation
6 - Support ring - fuel rail wields force via support ring to hold
fuel injector tightly in cylinder head
Removing
WARNING
♦ Fuel system is under high pressure! Before opening high
pressure components of the fuel injection system, pressure
must be relieved to residual pressure ⇒ page 2 .
♦ Then wrap a clean rag around the connection and relieve
residual pressure by carefully loosening the connection.
– Remove upper part of intake manifold ⇒ page 29 .
– Remove corresponding intake manifold lower-part
⇒ page 32 .
Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
5. Removal and Installation 35
To Next Page
Loading...
