Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– To fasten high-pressure line (17 mm) to high pressure pump,
use torque wrench -V.A.G 1331- with reversible ratchet -V.A.G
1331/1- and socket -T40055- .
– Install intake manifold upper-part ⇒ page 29 .
– Install front coolant pipe ⇒ Engine Mechanical; Rep. Gr. 19 ;
Removal and Installation .
– Fill with coolant ⇒ Engine Mechanical; Rep. Gr. 19 ; General
Information .
Tightening Specifications
Component Nm
High pressure pump to cylinder head 10
High pressure lines to high pressure pump 25
5.6 Engine Control Module
Special tools and workshop equipment required
♦ Heat gun 220 V/50 Hz -VAS 1978/14- -1- with nozzle attach‐
ment -2- from wiring harness repair kit -VAS 1978A-
♦ Locking pliers -3- (commercially available)
Note
♦
The Engine Control Module (ECM) -1- is bolted to a protective
housing -5-. To make removal of shear bolts -4- for retaining
tabs -2- more difficult, the threads are coated with locking
compound.
♦
To disconnect the connectors from the Engine Control Module
(ECM) (e.g. to connect the test box or to replace the ECM),
the protective housing must be removed.
Removing
– If Engine Control Module (ECM) was replaced, select diag‐
nostic object “Replacing Engine Control Module (ECM)” in
“Guided Fault-Finding” ⇒ Vehicle diagnosis, testing and infor‐
mation system VAS 5051.
– Turn ignition and remove ignition key.
– Remove rubber seal -1- for plenum chamber cover.
– Remove plenum chamber cover -2-.
Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
5. Removal and Installation 41
To Next Page
Loading...
