Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect check valve -1- from air duct hose.
– Remove air duct hose, thereby loosening hose clamp -2- and
opening clips -arrows-.
– Remove bolts -arrows-.
– Remove air duct -1- and -2-.
– Open clips -arrows- and remove upper part of air filter housing.
– Disconnect electrical harness connector -1- for Heated Oxy‐
gen Sensor (HO2S) -G39- and free up wire.
Note
Ignore -2 -.
Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
5. Removal and Installation 45
To Next Page
Loading...
