Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect electrical connectors at Intake Manifold Tuning
(IMT) valve position sensor -G513- -1- and at high pressure
pump -2-.
– Disconnect electrical harness connectors.
1 - Camshaft Position (CMP) sensor 2 -G163-
2 - Camshaft adjustment valve 2 -N208-
3 - Camshaft adjustment valve 2 (exhaust) -N319-
4 - Camshaft Position (CMP) sensor 4 -G301-
– Remove bolts -arrows- and disconnect electrical connections
at ignition coils.
– Set electrical wiring harness aside.
Continuation for Both Sides
– Remove ignition coils using ignition coil puller -T40039- .
Installing
Installation is in reverse order of removal.
Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
3. Removal and Installation 59
To Next Page
Loading...
