EasyManua.ls Logo

Audi A7 2017 - Page 244

Audi A7 2017
284 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Emergency assistance
Repairing tires
Applies to: vehicles with tire mob ility kit
Fig. 199 Components of the tire mobili ty kit
Fig. 200 Tire mobility kit connecti on
Requirement: the tire mobility kit must be laid
out and ready for use
o page 240.
Installing the tire mobility kit
.. Open the cover @ on the compressor
¢ fig. 199 .
.. Remove the connector @) and pressure hose ®
with pressure gauge from the housing.
Install the compressor pressure hose ® onto
the fla nge @ on the tire sea lant bottle
(D.
.. Insert the sealant bottle with the flange at the
bottom into the opening @ on the compressor
cover.
.. Remove the valve cap from the fau lty tire.
.. Install the filler hose @) on the valve 0
o fig. 200 .
.. Connect the plug @ ¢ fig. 199 to a socket in
the vehicle.
.. Switch the ignition on.
Inflating a tire
.. Move the switch @ o fig. 200 on the compres-
sor into position
I.
242
.. Inflate the tire between 29 PSI and 36 PSI (2 .0
and 2.5 bar) and read the tire pressure on the
gauge .
.. If this tire pressure is not reached , remove the
filler hose. Drive slowly approximately 10 m
forward or in reverse so that the sealant can be
distr ibuted in the t ire. Pump up the t ire again
¢ _&. .
.&_ WARNING
- Read and follow the manufacturer's safety
precaut ions on the compressor and in the
instructions on the bottle of sea lant .
- If a tire pressure of 29 psi (2.0 bar) cannot
be reached after inflating for six minutes,
then the tire is too severely damaged. Do
not continue driving.
- If the tire cannot be repa ired with the tire
sealant, see an authorized Audi dealer or au-
thorized Audi Service Facility for assistance.
(D Tips
Do not operate the compressor fo r more than
six minutes continuously, or it can overheat.
Once the compressor has cooled, you can con-
tinue to use it.
Completing
Appli es to : vehicles wit h t ire mob ility kit
.. Adhere the sticker that says "max. 50 mph"
(80 km/h) that is provided with the tire mob ili-
ty kit within the driver's field of vision.
.. Stop the vehicle after driving for about 10 mi-
nutes and check the t ire pressure.
.. If the tire press ure is lower than 19 PSI (1.3
bar), then t he tire is too severely damaged. Do
not continue driving .
.&_ WARNING
Pay attention to the following after repairing
the tire:
- Do not drive faster than 50 mph (80 km/h).
- Avoid hard acceleration, braking sharply,
and fast cornering .
- The vehicle may become more difficult to
control.

Table of Contents

Related product manuals