co
co
....
N
"
N
....
0
00
<.,;)
'SI"
Adjusting the height
The height of the display can be adjusted to the
individual driver.
.. Make sure you are seated correct ly
<=>page 130.
.. Turn the knob ~ to adjust the display.
Settings in the Infotainment system
.. Select: the ICARI fu nction button > (Car)* Sys-
tems
control button > Driver assistance >
Head-up display > Head-up display contents or
Display brightne ss.
Display content
In the Infotainment system, you can specify
which informa ti on should be displayed: For ex-
ample, th is can include navigation informat ion*,
Adaptive cruise cont rol* or night vision ass ist *.
The display of certa in information and some of
the red indicator lights cannot be hidden in the
Infotainmen t system .
Display brightness
You can adjust the display brightness in the Info-
tainmen t system. The display brightness decreas-
es automatically as the amount of light decreas-
es . The background bright ness is adjusted with
the instrumen t illum ination <=:>
pag e 43 .
(D Note
To prevent scratches on the glass covering the
head-up display, do not place any objects in
t he projection opening.
(D Tips
- Sunglasses with polar izat ion filt ers and un-
favorab le lighting conditions can have a
negative effect on th e display.
- An optim um display depe nds on the seat
position and t he height adjustment of th e
head-up display.
- A special windshield is needed for t he head -
up display function.
- For informat ion on cleaning, refer to
c::> ta -
ble on page 237.
Driver in f orma t ion system
On Board Diagnostic
System (OBD)
Malfunction Indicator Lamp (MIL)
The Malfunction Indicator Lamp (MIL) ¢• in the
inst rument cluste r is part of the On-Board Diag-
nostic (OBD
II) system .
The warning/i ndicator light illuminates when the
ignition is switche d on and goes out after the en-
gine starts and the idle has stab ilized. This indi-
cates that the MIL is working properly.
If the light does not go out after the eng ine is
started, or illuminates while you are driving, a
malfu nction may exist in t he engine system . If
t he light illuminates, the catalytic converter
could be damaged.
Continue driving
with reduced power (avoiding
sustai ned high speeds and/o r rapid accelera-
t ions) and have the condition corrected. Contact
your aut horized Audi deale r.
If the light illuminates, the elect ronic speed lim-
iter may also be ma lfunct ioning. For more infor-
mation
c::> page 26, Electronic speed limiter.
An improperly closed fuel filler cap may also
cause the MIL light to illuminate
<=> page 193 .
On-Board Diagnostics
Fig. 14 Location of Data Link Connector (DLC)
On-Board Diagnosti cs monitors the components
of your emissio n cont rol system . Each monitore d
component in your engine system has been as-
signed a code . In case of a malfunction, the com-
ponent will be ident ified and the fault sto red as a
code in the contro l modu le memory.
II>
25
To Next Page
Loading...
