Warm and c ol d
Fig. 72 4-zone deluxe automat ic climate control system:
rear controls
Press the buttons to turn the functions on or off.
Use the controls to adjust the temperature, the
blower speed and the air distribution. The LED in
a button will light up when the function is
sw itched on . The front settings are shown in the
climate control system display and in the Info-
tainment system disp lay for a few seconds . The
driver and front passenger settings can be ad-
justed separately.
The settings can also be adjusted in the rear
~ fig. 72.
IO FF ! Switchin g the climate control system
on/ off
The I OFF I button switches the climate control
system on or off. It also switches on whe n you
press the cont rol. Airflow from outside is blocked
when t he climate control system is switched off .
The
IO FF I button in the rear only switches the A/C
system on/off in the rear of the vehicle.
IA/C l Switching cooling mode on/ off
The air is not cooled and humidity is not removed
when cooling mode is switched off . This can
cause fog on the windows. The cooling mode
switches off automatically when there are cold
outside temperatures.
l"""I Switch ing recirculation mode on/ off
In recircu lation mode, the a ir inside the vehicle is
circu lated and fi ltered. This prevents the unfil-
tered a ir outside the vehicle from entering t he
vehicle inter ior. We recommend switching recir -
culation mode on when driving through a tunne l
or when sitting in traffic ~ .&..
62
The !AU T OI button or I@ FRON T I button switches
recircu lation mode off .
IAUTO I Switching automatic mode on
Automat ic mode maintains a constant tempera-
ture inside the vehi cle. Air temperature , a irflow
and air distrib ution are controlled automatica lly.
If press and hold the button longer,
72 °F (22 °C)
will be set.
Adjusting the temperatu re
Temperatures between 60 °F (+16 °() and 84 °F
(+28 °() can be set . Outside of this range, LO or
HI will appear in the climate control system dis-
play. In both settings, the climate control runs
constantly at the max imum coo ling or heat ing
level. The temperature is not regu lated .
Adjusting the blower ~
You can adjust the volume of air generated by the
blower t o your preference . The blower should al-
ways run at a low setting to prevent the windows
from fogg ing and to ensure a cont inuo us ex-
change of a ir inside the vehicle . To have the blow -
er regulated automatically, press the
IAU T O I but-
ton.
~
Adjusting air distribution
You can man ua lly select the vents where the air
will flow. To have t he air distr ibut ion regulated
automat ically, press t he
IAU T O I button.
~
Adjusting seat heat ing*/ seat ventilation*
Pressing the button switches the seat heating/
seat ventilation on at the highest setting (level
3). The LEDs indicate the temperature level. To
reduce t he temperat ure, press the button again.
To switc h the seat heat ing/seat ventila t ion off,
press the button repeatedly until the LED turns
off.
After
10 m inutes, the seat heating au tomatically
switches from level 3 to level 2.
l<ii> FRON T I Switching the defroster on/ off
The w indshield and side windows are defrosted
or cleared of condensat ion as quick ly as poss ible.
The maxim um amount of air flows mainly from
t he vents below the windsh ield. Recirculation ..,.
To Next Page
Loading...
