Advanc e d Parking Sy s t e m -
----------------=---=------'
• Keep the sensors in the rear bumper and the rear-view camera
lens clean and free of snow and ice, so that the Audi parking system
can work properly . Please follow the additional notes on
~
page 183. •
Applies to ve hicles: with Ad van ced Parking Sys te m w ith rear vi ew cam era
Rear-view camera (Rear View)
The rear-vie w camera picture, appearing in the MM!
Display, shows the are a behind the vehicle.
-
'
Ll
--
.
-
.
-
Fig. 194 Top view :
Parking mode 1
Fig. 195 Top view:
Parking mode 2
Pa rki ng mode
Two different parking modes are available for parking with the rear-
view camera . The two different park ing modes are denotes as
" parking mode 1"
~
page 175 and "parking mode Z'
~
page 176.
Controls and equip-
ment
" Parking mode 1" => fig. 194, for examp le, can be used to park in a
parking space or a par king garage ::::>
page 175.
"Parking mode 2" => fig . 195, for examp le, can be used to (parallel)
park on the side of the road
~
page 176.
"Parking mode 1" appears by defau lt in t he MMI Display if the rear-
view camera is activated =>
page 170. You can switch to "parking
mode
2" by pressing the control button with the mode @
=> page 175, fig. 199 function . By repeated ly pressing the control
button w ith the
mode function, you can sw itch back and forth
between " par king mode
1" and "parking mode 2" .
Orientation lines and marked surfaces
Orientation lines and colored marked surfaces(::::> page 175, fig . 198
or =>
page 176, f ig . 200) are projec t ed into the rear-view came ra
pictures , subject to the two different parking modes . These orienta -
t ion lines and surfaces offer aid when parking or maneuvering. The
orientation lines and surfaces refer to the height of a leve l driving
surface .
When the indicated orientation lines and indicated blue surfaces
superimpose vehicles or objects, at the latest , the respective
distance to the vehicles or objects has become too short
=>
page 179.
If the trunk lid is open or if an electrica l connection to the trailer
socket* is established::::>
page 180, the orientation li nes and marked
surfaces are
not displayed.
In the MMI you can preset which system is to be shown on the MMI
display =>
page 182".
• Visual di splay,
• Rear-view camera picture,
• An aut omatic switch between visual disp lay and rear-view
camera , or
• No picture .
The rear-view camera can be turned on and off in the MMI
=>
pag e 182. The acoust ic d istance wa rning remains active.
Vehicle care
I I
irechnical data
To Next Page
Loading...
