Audi A8 2008 - Settings in the MMI

___ A_ d_v_a_n_c_e_d_ P_a_r_k_in~g_ S_y_s_t_e_m ___________________________________________ _
&, WARNING (continued)
• Maintain plenty of distance from an obstacle, so that your
outside mirror or a corner of your vehicle does not collide with any
obstacles - danger of accident!
• The Audi parking system is not a substitute for being careful
and alert when backing up. Be especially careful during parking
and similar maneuvers. Always watch where you are driving and
make sure that nothing is in the way.
• When maneuvering or parking, do not only use the MMI Display
for orientation. Certain objects - depending on the screen resolu-
tion - may not, or not entirely, be displayed; for example trailer
hitches, chains, narrow posts, or fences . •
App li es to vehicles: with Adva nced Parking System with rear view came ra and a tra il er hitch
installed according to factory spec ifications
Towing hitch
For vehicles with a trailer hitch installed according to factory speci-
fications, the rear acoustic parking sensors are not activated when
the vehicle is put in reverse gear while an electrical connection to
the trailer socket* is established . No distance alert occurs in the rear
=> page 170. The rear-view camera picture => page 173 is displayed
without orientation lines and without blue surfaces. •
Settings in the MMI
App lies to vehicles : w ith Advanced Par king System with rear view camera
Adjusting the chimes - option 1
The volume and the pitch (frequency) of the chimes can
be adjusted in the MM/.
Fig. 205 MMI display:
Selection menu
- Press the [CAR] function button.
- Select
Systems in the CAR menu.
- Select
Audi parking system .
- Select Front volume to change the volume of the front
audible signal generator, or
Rear volume to change the
volume of the rear audible signal generator.
- Select
Front frequency to change the frequency of the
front audible signal generator or
Rear frequency if you
want to change the frequency of the rear audible signal
generator.
When you adjust the volume and frequency, the new setting will
sound for approximately 2 seconds from the signal generator
affected.