___ H_o_m_ e_L_i_n_k_® __________________________________________________ _
Prog ram min g th e bump e r m o unt e d tr a nsmitt e r
1. Hold t he original remote control at a distance between 0-
5 in . (0- 13 cm) from the bumper below t he appropriate
headlight for your vehic le (use the shortest distance
poss ible) .
2. Aim the remote control just below the driver side head -
light.
3. Press and hold the activation button on the remote
control.
4. The emergency f lashers will flash three tim es (after
about
15-60 seconds) when the programming is
successful. Now release the button on the remote
control.
- If the dev ice utilizes a rollin g code, please follow phase 3
of ~
page 191, "Programming the Home li nk® trans -
mitter" for ro ll ing code programming .
This procedure wi ll cause the existin g programm ing on t he
Homelin k® butt on to be erased ! •
Ap plies to vehi cles: wit h Hom eli nk® u niversal rem ote con tro l
Erasing the programming of the Homelink ®
transmitter
When you erase the programming, the programming on
all three of the transmitter channels with be lost!
- Perform steps 1 to 4 as described on ~ page 192, "Phase
1: programming the overhead keypad".
When comp leted, the Homelink ® system will be in the program -
ming mode and is t hen ready to learn the codes for remote
controlled devices.
[ i ] Tips
• Programmed buttons cannot be erased ind ividua lly.
• For security reasons you are advised to erase the programming
of the Homelink ® system before you sel l your vehic le. •
Ap plies to vehicle s: w it h Hom elink® universa l rem ote co nt ro l
Information and accessories
If you wou ld like more information on Homelink ®, where to
purchase the Homelink® compatib le products, or would like to
purchase the Homelink ® Home Lighting Package, please cal l toll -
free: 1-800-355 -3515.
[ i ] Tips
• The Homelink ® universal transmitter compl ies with part 15 of
the FCC ru les and RSS-210 of IC part 15. Operation is subject to the
f ollowing cond it ions :
- this device may not cause harmful interference, and
- this device must accept any interference that may be received
including interference that may cause undesired operation .
• Changes or mod ificat ions not express ly approved by the party
responsible for compliance cou ld void the user's authority to
operate the device (DOC: ISTC 1763 102 264 Prince MODEL/FCC ID:
CB2 V94800l. •
To Next Page
Loading...
