________________________________________________ E_m_e_r.::.g:...e_n_ c_,y'--s_i_t _u_a_t_i_o_n_s _ ___._
& WARNING
A vehicle being towed is not safe for passengers. Never allow
anyone to ride in a vehicle being towed, for any reason. •
Towing loops
When you screw in the towing loop, be sure to pay atten-
tion to the check markings.
Fig. 298 Check mark-
ings for towing loop
The check markings are there to show you when the towing loop is
completely and correctly screwed into the threaded holes.
When you screw the towing loop into the
front bumper, the check
marking @ must be flush with the bumper~ fig. 300.
When you screw the towing loop into the
rear bumper, the check
marking @ must be flush with the bumper
~
page 368, fig. 302. •
Front towing loop
Do not install the front towing loop until it is needed.
Fig. 299 Right front
bumper: Removing the
air intake grill
Fig. 300 Right front
bumper without grill :
Towing loop fully
screwed in
On the right front under the bumper there is a threaded hole
to receive the towing loop. The threaded hole is concealed
behind an air intake grill.
- Insert the screwdriver into the slots as shown::::> fig. 299
and press the top tab down and the lower tab up. At the
same time, pull the grill forward and out.
- Remove the towing loop from the vehicle tool kit. .,
Vehicle care Do-it-yourself service irechnical data
To Next Page
Loading...
