Opening and closing
[ i J Tips
• In order to make sure the locking function is working, you should
always keep your eye on the vehicle to make sure it is properly
locked .
• Do not use the remote control if you are inside the car, otherwise
you may unintentionally lock the vehicle, and then you would set off
the anti -theft alarm when you try to start the engine or open a door.
In case this happens anyhow, push the unlock button
0.
• Use the panic function only if you are in an emergency
situation. •
Operating locks with the key
To lock and unlock the vehicle from the outside, turn the
key in the lock of the driver's door.
Fig. 34 Key turns for
opening and closing .
The lock cylinder is under the door handle.
To unlock the vehicle
Insert the key into the lock of the dr iver's door.
Turn the key
one time to position © to unlock the driver's
door.
- Turn the key
two times to position @ => fig. 34 to unlock
all doors and the rear lid.
To lock the vehicle
- Close all windows and doors properly.
- Turn the key in the lock of the driver's door to the lock
position ® =>
& in "General description" on page 49.
& WARNING
Read and follow all WARNINGS
~
& in "General description" on
page 49. •
Settings in MMI
Selective unlock feature - the driver can determine in MM/
which doors are unlocked through the central locking
system.
Fig. 35 MMI display :
Central locking menu
- Pressthe (CAR )function button.
- Select
Systems in the CAR menu.
- Select
Central locking. The Central locking menu appears
=> fig. 35. _,.
To Next Page
Loading...
