Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolts -1 and 3- and take out longitudinal member
-2-.
– Release hose clip -2- and detach air pipe.
– Remove bolts -arrows- and detach air cleaner (top section)
-1-.
– Turn air filter element in anti-clockwise direction -arrow A- and
detach it.
Installing
• Tightening torques
⇒ „2.3 Air cleaner - exploded view“, page 17
Note
♦
Always use genuine part for air filter element.
♦
The air cleaner housing MUST be clean.
♦
Hose connections and hoses for charge air system must be
free of oil and grease before assembly.
♦
Use a silicone-free lubricant when installing the air hoses.
♦
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue .
♦
To prevent malfunctions, cover all critical parts of the engine
air intake tract (intake pipes, etc.) with a clean cloth when
blowing out the air cleaner housing with compressed air.
♦
Observe environmental requirements for disposal.
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2. Injection system 19
To Next Page
Loading...
