Audi A8 2010 - Page 53

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Move clear wiring harness at plenum chamber cover on bulk‐
head on both sides (release catches -arrows-).
– Detach electrical connector -1- from bracket and unplug.
– Use removal lever -80 - 200- to move electrical wiring harness
at body brace clear.
– Remove bolts -1, 2, 3- and -arrows- and detach body brace.
– Release clips -arrows- and detach engine control unit -J623-
-item 2-.
Note
Disregard -items 1, 3, 4-.
Installing
Installation is carried out in the reverse order; note the following:
– Install body brace ⇒ Rep. gr. 40 .
After installing a new engine control unit, the following operation
must be performed:
– Activate engine control unit using ⇒ Vehicle diagnostic tester
in „Guided Functions“ mode, „Replace engine control unit“.
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
3. Engine control unit 49