132 Homelink
@ Tips
To open the garage door, press the button,
but do not press it for longer ten seconds
or the Homelink modu le will switch to
programming mode.
Programming transmitters
Applies to vehicles: with Home link
Fig. 152 Left front area of the bumper
You can program both fixed code and rolling
code systems using these instructions .
Programming a button
> Make sure your veh icle is wit hin operating
range of the remote controlled garage door
opener .
> Set the parking brake¢ .&. in General infor-
mation on page 131.
> Switch the ign ition on. Do not start the en-
gine!
> There are two ways to program a button:
press the button that you would like to pro -
gram. The MMI will display instruct ions to
guide you through the programming. Or
> Se lect: I CAR I function button> Car systems
control button > Vehicle settings > Garage
door opener
> Program garage door open-
er.
.. Se lect the button that you would like to pro-
gram.
.. Follow the instructions in the MMI.
• If the garage door open ing must also be
synchronized with the Homelink module,
refer to the owner's manual for the garage
doo r opener .
Erasing the button programming
> Select: I CAR I function button > Car systems
function key > Vehicle settings> Garage
door opener
> Clear program settings >
Yes.
Displaying the version/status/country
code
.. Select: I CAR I function button > Car systems
contro l button > Vehicle settings > Garage
door opener > Version information .
Programming a button
The requ ired distan ce between th e handheld
transmitter and the Homelink modu le in the
bumper depends on the system that you are
programming. When programming a new de-
vice, keep the button pressed for at least 15
seconds before trying aga in with the transmit-
ter in a different position.
Each of the buttons can be reprogrammed in-
dividua lly. The procedure is the same as for in-
itial programm ing.
c> page 132, Programming
a button.
Erasing the button programming
Ind ividual buttons can be reprogrammed . Fol-
low the same steps used when first program-
ming the button.
If you would like to erase all prog rammed but-
tons at the same time, select Erase button
programming.
(D Tips
- To ensure your safety, eras ing the pro-
grammed Homelink buttons before sell-
ing the vehicle is recommended.
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming.
To Next Page
Loading...
