....
N
....
N
0
J:
'<I'.
....
I.O
"'
....
"'
....
Vehicle tool kit
Vehicle tool kit and jack
The vehicle tool kit is located in the luggage
compartment under the cargo floor cover.
Fig. 217 Luggage compartment: cargo floor cover
folded upward
Fig. 218 Trunk lid: Vehicle too l kit
.. Lift the cargo floor by the plastic handle.
.. Hook the handle into the luggage compart-
ment weather strip ¢
fig. 217.
.. Remove the spare wheel to reach the vehicle
tool kit .
.. Remove the foam piece.
The onboard tool kit includes:
- Hooks to remove the wheel covers* or wheel
hub covers
- Plastic hook to remove wheel bolt covers*
- Wheel bolt wrench
- Alignment pin for changing wheels
- Screwdriver with reversible blade
- Towing loop
- Jack
Before storing the jack, make sure it is wound
back down as far as it will go.
What do I d o now ? 26 7
A WARNING
Im proper use of the vehicle jack can cause
serious personal injur ies.
- Never use the screw driver hex head to
tighten wheel bolts, since the bolts can-
not attain the necessary tighten ing tor-
que if you use the hex head, potentially
causing an accident.
- The factory-supplied jack is intended on-
ly for your vehicle model. Under no cir-
cumstances should it be used to lift
heavy veh icles or other loads; you risk in-
ju ring yo urself.
- Never start the engine when the vehicle
is raised, wh ich could cause an accident.
- Support the vehicle securely with appro-
priate stands if work is to be performed
underneath t he vehicle; otherwise, there
is a potentia l risk for injury.
- Never use the jack supplied wit h your
Audi on another vehicle, particularly on a
heavier one. The jack is only s uitable for
use on the vehicle it came with.
(D Tips
- Some of the onboard items listed above
are provided on certain models only or
are optional ext ras .
- Before yo u can raise your vehicle using
the jack, you must activate the jacking
mode
¢page 272 .
To Next Page
Loading...
