....
N
....
N
0
J:
'<I'.
....
I.O
"'
....
"'
....
(D Note
Do not lift the vehicle by the sill. Position
the vehicle jack only at the designated lift-
ing points on the sill. Otherwise, your vehi-
cle will be damaged.
(D Tips
The vehicle jack mode switches off auto -
matically at speeds above 10 km/h.
58 : Raising the vehicle
The vehicle must be li~ed with the jack first
before the wheel can be removed.
Fig. 226 Sill pane ls: mark ings
Fig. 227 Sill: posit ioning the veh icle j ack
.. Activate the vehicle jack mode in the MMI:
I CARI funct ion button > Car syst ems control
button
> Servicing & checks> Air susp.:
ja ck mode
> On.
.,. Engage the parking brake to prevent your
vehicle from rolling unintentionally.
.. Move the
selector lever to position P.
.. Find the ma rking (imprint) on the sill that is
nearest the wheel that w ill be changed
r=> fig . 226. Behind the marking, there is a
lifti ng point on the sill for the vehicle jack.
.. Turn the
vehicle jack located under the lift -
ing point on the sill to raise the jack until its
What do I d o now ? 27 3
arm @ r=> fig . 22 7 is located under the des-
ignated plastic mount
r=> A. in AB: Raising
the vehicle on page 272 i::>(f).
.. Align the jack so that its arm @ c::> fig. 22 7
engages in the designated lifting point in
the door sill and the movable base @ lies
flat on the ground. The base @ must be
ver-
tical
under the lifting point @ .
.. Wi nd the jack up fu rther until the flat t ire
comes off t he ground
r=> &,. in AB: Raising
the vehicle on page 272.
Position the vehicle jack only under the desig-
nat ed lifting points on the sill
c::>page 272,
fig. 224 . There is exactly one location fo r each
wheel. The jack must not be positioned at any
other location c::>
.&. in AB: Raising the vehicle
on page 2 72 r=>
(J).
An unsta ble surf ace under the jack can cause
the vehicle to slip
off the jack . Always provide
a firm base for the jack on the gro und. If nec-
essary place a sturdy board or simi lar support
under the jack. On
hard, slippery surf aces
(such as tiles) use a rubbe r mat or similar to
prevent the jack from slipping c::>
,&. .
.&_ WARNING
- You or your passengers could be injured
while changing a wheel if you do not fo l-
low these safety precautions:
- Position the vehicle jack only at the
designated lifting points and align the
j ack. Otherw ise, the vehicle jack could
slip and cause an injury if it does not
have sufficient hold on the vehicle.
- A soft or unstable surface under the
j ack may cause the vehicle to slip off
the jack . Always provide a firm base for
the jack on the ground .
If necessary,
use a st urdy board under the jack .
- On hard, slippery surface (such as t iles)
use a rubber mat or similar to prevent
the jack from slipping .
- To help prevent injury to yourself and
your passengers:
- Do not raise the vehicle until you are
sure the jack is securely engaged.
To Next Page
Loading...
